Control function
Controlled axis:X,Z,
Min. command unit:0.001mm

Interpolation ways:X,Z axis linear, circular interpolation

Programming command range:+-9999.999mm
Max. rapid speed:7600mm/min 30000mm/min(adaptive)

Max. feed speed: linear speed 7600mm/min(electric gear ratio 1:1)

Feed per rev:0.001~500mm/Rev(must equipped with 1024 P/r spindle coder)

Feedrate override:0~150% 16 grades tune real time

Rapid override:25%,50%,75%,100%

Acceleration/deceleration mode:the linear rapid acceleration/ deceleration, the index feed acceleration/deceleration,the parameter can be tuned

electric gear ratio:1~127/1~127
Electronic handwheel function: with

Display windows
Monitor display type:320X240 lattice in blue(LCD),CCFL in a poor light

Display mode: Chinese(adaptive English menu)
Diagram display function: with

G function
23 kinds of G command, including 3 single fixed and 7 compound cycle commands, 8 user read/ write macro commands, max. 16 input/6 output points, double subprogram call, user macro program call

Thread function
Metric/Inch single straight thread, taper thread, metric/inch face thread. And the ending of thread can be set( set by the parameter)

Pitch:0.001~500.000mm(metric) 0.06~254000.000 tooth/inch ( Inch)

Spindle coder:1024p/r incremental coder

Compensation function
Backlash compensation:(X,Z axis)

Pitch error compensation:(X,Z axis)(adaptive)

Tool point radius compensation:(X,Z axis)(adaptive)

Tool compensation:16 groups tool length compensation

Tool function
Adaptive toolpost:max. setting 8 tool selections electric toolpost(can adapt 12 tool selections toolpost function, select the near toolpost without chuck/tailstock control function)

Tool selection signal input mode:directly input

Tool change mode:MDI/automatic absolute tool change or manual relative tool change, tool selection by forward rotation, clamp by backward rotation

Toolsetting mode: fixed point and trial cutting toolsetting

Tool compensation mode: move the tool/coordinate offset(set by parameter)

Spindle control
Control mode: 4-gear or analog control

Gear control:S1,S2,S3,S4 direct output

Analog control: set as 4-gear spindle auto or manual shifting, and output 0~10V control spindle speed

Constant linear cutting function: with( its function is valid when select the spindle analog control)

Auxiliary function
Control the spindle start/stop, reverse, stop; coolant On/Off; lubricate start/stop; chuck clamp/unclamp; tailstock feed/retract in Manual/MDI; control the spindle frequency conversion automatic shifting in MDI/Auto mode

Program edit
Program capacity:40KB,63 programs

Subprogram:can be edited

Communication
Standard RS232 communication interface;adaptive communication function and supplying for the communication software and cable, transmitting the program with PC each other

Anti-interference ability
Meet GB/T17626.2

Adaptive part
Switch power supplying:GSK PB(match with it and have been installed and connected)

Driving device:DF3A 3-phase response,DY3B 3-phase compound,DA98 series AC servo

Toolpost controller:GSK TB

Assembly
Standard panel,big panel, box

Integrated outing wire from the bottom/back(matching with DF3A or DY3B)

Dimension
420x260x136mm/ 420x320x136mm(samll/big)

Weight
6.0kg(containing switch power supplying)